The EVlink Pro AC is a wall-mounted charging station for electric vehicles. It complies with the IEC 61851-1 standard. It can also be placed on the ground, fixed on a base or integrated into a kit box. The base and housing kit must be ordered separately. It can be installed indoors or outdoors. IP degree of protection: IP55. Degree of protection IK: IK10. The operating temperature is between -30¡C and 50¡C. Storage temperature is between -40¡C and 80¡C. The output consists of a 5 m cable fitted with a T2 connector with a valve (T2S) at the end, mounted at the top of the terminal. All T2 connector contacts are silver plated to prevent overheating. The rated output power is 22 kW. It has a three-phase power supply (3P+N). The rated load current is 32 A at 380 V to 415 V AC with a frequency of 50 Hz to 60 Hz. It can be used with a TT, TN-S or TN-CS grounding system. It can also accommodate an additional isolation transformer on the power supply. This charging station is simple to install and put into service. It is suitable for use at home, but also for vehicle fleets, on the street or in the workplace. These dimensions are: 317mm (w) x 529mm (h) x 183mm (d). It weighs 10 kg and is white (RAL 9003). It incorporates protection against leakage current and has a 6 mA leakage current detection device (RDC-DD) and a 30 mA A-Si type differential circuit breaker (RCD). For safety reasons, it also has a disconnection device in the event of MNx undervoltage. In addition, it is necessary to meet the requirements of the EV Ready label. The latter can be powered by a cable coming from the rear, top or bottom of the terminal. To charge an electric vehicle, access control is done via user authentication using an RFID or NFC badge. The charging station can also be used freely. The start of charging can be delayed. During charging, it is possible to limit the power in order to ensure continuity of service and to optimize the charging time of all terminals based on the same power source. The terminal has 2 RJ45 Ethernet ports to connect to the local network. To set the settings, use the eSetup app via Bluetooth or EcoStruxure EV Charging Expert. The charging station can be managed autonomously or in a cluster architecture. The OCCP 1.6 communication protocol allows you to connect to the tracking device. The charging station has functions such as charging data, diagnostics and charging management. It is CE and EV Ready certified.
